• Buyers Guide 2005 home
  • Buyers Guide 2005 Outside Athelte
  • Buyers Guide 2005 Outside Expidition
  • Buyers Guide 2005 Outside Travel
  • Buyers Guide 2005 Outside Style
  • Buyers Guide 2005 Gear of the Year
  • Buyers Guide 2005 Gear to Covet
  • Buyers Guide 2005 Killer Values
  • Letter from the editor

Browse Outdoor Gear

Gear Blog Gear Guy

Today's Question
What set of walkie-talkies should I get for a three-month trip on Hawaii’s Big Island? answer

Who makes the best three-season one-person condensation-free tent? answer

Gear Favorites

Buyers Guide 2004

 Outside Buyers Guide 2005


2004 Buyer's Guide: Bike Care
BEFORE YOU GO
» Inflate tires to the recommended range, 35– 60 psi for mountain bikes, 100–115 psi for road bikes. Make certain your spare tube, tire levers, and pump are all HEALTHY AND ON BOARD.
» Squeeze both brake levers. The brake pads should hit rims (not tires) squarely, and the levers shouldn't bottom out against the bars.
» A loose wheel is a potential disaster. Be sure the quick-release lever is SECURED.
» GIVE A QUICK TUG TO OTHER PARTS, like water-bottle cages, handlebars, seat, and cranks, to make sure nothing's about to fall off.
» Check your front shock by leaning on it, hard. If it chatters, put a few drops of lube under the boots (the accordion-like rubber sleeves). Still rough? Hotfoot it to the shop. Ditto for the rear shock. If your shocks are air-sprung, make sure to pump up to the recommended pressure.
» CLEAN AND LUBE your chain. Use a toothbrush to scrub the drivetrain with degreaser. SPIN THE PEDALS BACKWARDS and dribble lubricant on the roller parts of the links as they pass; wait a few minutes and remove the excess. Lube every few rides; clean half as often.

ON-THE-FLY FIXES
» Does the front end rattle? Your headset is loose. LOOSEN THE TWO BOLTS on the side of the stem and tighten (half a turn) the single bolt on top of the stem. Retighten the side bolts. Repeat until the clunk is gone, but make sure the bars still turn freely.
» Gears slipping? TURN THE ADJUSTING BARREL where the cable enters the rear derailleur; start with one counterclockwise turn.
» Brakes dragging on one side? On mountain bikes, use a screwdriver or hex wrench to TURN THE SCREWS outside the brake arm, near the pivot point. Roadies can twist the whole brake caliper by hand until it's centered.